3. Press"choice"(figure 2),change working model to "manual"(figure 3)
First start Hot Transfer pump to force Transfer Oil in a movement of circuit, and five minutes later, turn on the Heating Switch. When shutdown working, firstly turn off Heating Switch, and keep oil pump still working until 30 minutes later, when Hot Transfer Oil cool down, then oil pump could be turned off
4. Working model choice: F1 loading once, F2 loading twice,
F3 veneer model, F4 silicone prepress
Button F1-F4 lie in right of screen, press as choosing; different models recording to different product technology, temperature adjusted by model changing. Models choice only works in state of ' Manual '. Cannot change model in automatic operation.
5. Temperature setting: air temperature set to be 100. start lower heating board when make high gloss pvc, generally it is 55℃, in sumer, according to the indoor temperature, no more than 50℃
Upper heating board temperature:
set by working model and pvc. when in F1 and F2, Set 135℃ for flat gloss pvc, 100℃ for high gloss pvc; when in F3, 120℃ set for veneer products; when in F4, 85℃ set for high gloss pvc.
6. Parameter setting
chose "choice" to "parameter setting", like figure 4. First chose working model, then next, get in the figure of parameter setting (figure 5 and 6). Attention, two figures must be both set, no forgotten.